Laptop Shell Spray Painting Machine
Laptop shells and similar electronics housings need even cosmetic coating with no edge build-up. Lynvex machines for this work are the QF-FS and QF-FD series, offered in four models.
Home › Laptop Shell Spray Painting Machine
Laptop shells and similar electronics housings need even cosmetic coating with no edge build-up. Lynvex machines for this work are the QF-FS and QF-FD series, offered in four models.
The model range for laptop shell spraying is QF-FS6060, QF-FD6060, QF-FS8080 and QF-FD8080. The machine size for this family is W2000 x D2000 x H2400 mm, or customised to your shells and fixtures. Model choice follows your shell size and discs per cycle.
| Model | Series note |
|---|---|
| QF-FS6060 | FS series |
| QF-FD6060 | FD series |
| QF-FS8080 | FS series |
| QF-FD8080 | FD series |
| Machine size | W2000 x D2000 x H2400 mm, or customised |
Housings show every defect, so dust control before spraying and a clean booth matter as much as the machine. Pair this machine with an electrostatic dust removal step and a water curtain booth if your finish spec is strict; tell us the spec and we will build it into the proposal.
This equipment is supplied with a 12-month warranty. Spare wear parts (guns, nozzles, filters, belts) are listed in the quotation so you can stock them at commissioning.
Axis spray machines serve production where the same part repeats thousands of times: consumer electronics housings, helmets and protective gear, sanitary ware, toys and moulded plastic or metal components. The economic logic is repeatability — once the gun path, distance and speed are set for a part, every cycle repeats them, so film thickness stays even and paint consumption per part can be measured and tuned.
Two operating habits decide results more than the machine class does. First, fixture design: a part that sits 2 mm differently each cycle sprays differently each cycle. Second, gun maintenance: a worn nozzle changes the fan pattern long before it fails outright, so nozzle checks belong in the weekly routine. Both points are covered when a configuration is commissioned.
An axis machine is one station in a process. Upstream, parts usually need cleaning or electrostatic dust removal, especially moulded plastics that carry static. Downstream, the coating decides the next step: air-dry paints need flash-off space, baked enamels need an oven, UV coatings need a curing section. When you request a quote, name the equipment you already own for these stages; the machine will be specified to feed it, including conveyor height and part hand-off.
Smaller housings run on the same family with suitable fixtures. Send both part sizes if you plan mixed production.
Send your part drawings, part size and output target. We will confirm the machine or line configuration and reply with a quotation.